Guided Positioning

In this mode the positioning is performed directly via the Cali-OS of the CSC-Tool PRO.

For the guided positioning, however, you need to start the calibration manually with a diagnostic device.

Procedure

• Data elements of vehicle and calibration are selected manually
• The Cali-OS accompanies the customer step by step through the positioning of the CSC-Tool PRO right to the calibration
• Measured values are displayed and stored within the Cali-OS

Advantages

• Guided positioning of the reference panels
• The positioning itself and the steps of the procedure are assisted and do not depend on the diagnostic device used
• The positioning parameters and steps of the procedure are documented in the result protocol

Restrictions

• Vehicle data must be selected manually in the Cali-OS
• No feedback from the ECU possible
• The calibration results are not documented in the result protocol