CSC-Tool wheel clamps rim with 3D panels

NOTICE

notice

Determine the mounting position

Pay attention to the image printed on the 3D panel.

It specifies on which wheel (e.g. front left, rear right) the wheel clamp is to be mounted.

Attach the wheel clamp

  1. Position the wheel clamp in a way that all four contact points are equally on the rim edge.

Attach and align the wheel clamp

  1. Attach the wheel clamp.
  2. Tighten the wheel clamp consistently until it is firmly tensioned but not excessively tensioned.
  3. Check seat and field of view.
  4. Ensure that the wheel clamp is evenly in contact with the wheel.
  5. Ensure that the 3D panels are clearly visible within the visual field of the camera optics.
  6. Check the alignment.
  7. Check the horizontal alignment of the 3D panels with the integrated level.
  8. Correct the position if necessary until the level is centered.