Register CSM user

Proceed as follows to register a CSM user:

  1. Select Settings (1) > CSM users (2) > Add CSM user (3) auswählen.
  3. Select >Register new CSM user<.
  5. Enter the CSM user data and determine a password.
  6. Select >Register<.
  8. Registration of CSM user is started.
  10. A verification token is sent via e-mail.
  12. Select the CSM user.
  14. Release the user identification with >Confirm<.
  16. Select >Enter the verification token from e-mail<.
  18. The functions of the Cyber Security Management can only be used after an identity check through Hella Gutmann and IDnow.
  19. Enter the verification token from the e-mail (1) and confirm with >Verify e-mail address< (2).
  1. Another e-mail will be sent to the specified e-mail address. You can start the identification via IDnow with this e-mail.

identification with IDnow AutoIdent

We use IDnow AutoIdent to verify the identity in the course of the registration process. This requires the following points:

The following video shows the identification procedure with IDnow AutoIdent step by step:

► After successful identity check the device user receives a final confirmation e-mail.

► Now you can use the Cyber Security Management.