Performing a Battery Test

Proceed as follows to perform the battery test:

  1. Connect the BPC-Tool to the battery (see operating instructions for the BPC-Tool).
  2. Insert the electrical plug connection of the clamp meter into the ST3 connector of the BPC-Tool with the arrow pointing up.
  3. Select >Optional HGS Tools< in the main menu.
  4. Select Battery diagnostics with .
  5. Select >Battery test<.
  6. Open the list under Battery position with .
  7. Select >In the vehicle< or >Outside the vehicle<.
  8. Repeat steps 6 to 7 for another selection.
  9. Open the virtual keypad under Cold cranking amps [A] with where necessary.
  10. Enter a value.
  11. Confirm your entry with .
  12. Push to start the Battery diagnostics.
  13. The connection is established and the device searches for the BPC-Tool.
  1. The battery test is started.

From here, the system test is controlled using the keys on the BPC-Tool (see operating instructions of the BPC-Tool).