Performing Basic Settings

First select a vehicle before doing any basic settings.

For more information about the vehicle selection read the sections and CSM vehicle selection.

CAUTION

Wrong or incorrectly performed basic settings

Risk of injury or material damages to the vehicle

Regard the following when performing basic settings:

1. Select the correct vehicle type.

2. Regard the window with information and instructions.

Rolling of vehicle

Risk of injury or material damages

Proceed as follows before startup:

1. Apply the parking brake.

2. No gear is engaged.

3. Regard the window with information and instructions.

Danger of short circuit and voltage peaks when connecting the OBD plug

Danger of destruction of automotive electronics

Only connect the the OBD plug to the vehicle when the ignition is switched off. Then switch on the ignition again so that the VCI has power supply.

Proceed as follows to perform the basic setting:

Plug in the OBD plug in the vehicle's diagnostic connector.
Select the function >Basic setting< under > Diagnostics > Basic setting or directly using the drop-down menu on the left.
Select the requested assembly.
Select the requested function.
Select the requested system.
Follow the instructions on the screen and start the procedure with >Start<.
Regard the window with information and instructions.
Communication to vehicle is being established.
Follow the instructions on the screen.