CSM Vehicle Selection

NOTICE

These steps are necessary only if no CSM user has been registered before.

Proceed as follows to be able to select a vehicle with installed security system and to use the usual diagnostic processes without restrictions:

Select a requested vehicle in > Vehicle selection.
CAUTION
Rolling of vehicle
Risk of injury or material damages
Proceed as follows before startup:
1. Apply the parking brake.
2. No gear is engaged.
3. Regard the window with information and instructions.
NOTICE
Danger of short circuit and voltage peaks when connecting the OBD plug
Danger of destruction of automotive electronics
Only connect the the OBD plug to the vehicle when the ignition is switched off. Then switch on the ignition again so that the VCI has power supply.
Plug in the OBD plug in the vehicle's diagnostic connector.
Regard the window with information and instructions.
Close the info and instructions window.
Select the requested diagnostic type (e.g. >Service reset<).
The Login window appears.
Enter the CSM user data and select >Login<.
Confirm the user identification with >Confirm<.